Paver Seal

Seal your pavers with a high gloss sealant to make the colors more vibrant!

100-150 sq. ft. per gallon depending on surface

Thoroughly clean surface of joint sand, dust or loose material prior to application. Use Efflorescence Cleaner for removal of efflorescence and a Cleaner/Degreaser for removal of stains, as necessary.
Surface must be completely dry prior to sealer application. Recommended application temperatures are 50F (10C) to 80F(27C). Do not apply if inclement weather is forecasted within 24 hours.
Stir thoroughly prior to use . Product may settle. Do not dilute before applying. Can be applied with a sprayer or roller. For best results, apply with a clean, low pressure sprayer, that is approved for solvent usage. Start at the highest elevation of the pavement. Immediately follow up by back rolling the sealer using a Slit Foam Roller. This process will even out the application and prevent an uneven finish. Do not allow sealer to pool on the pavers or joints.
Do not allow sealed area to become wet until dry (24-hours). Dry-tack free: 25 minutes; Foot traffic: 24 hours; Vehicle traffic: 72 hours (Note: All calculations based upon 68-77º F (20-25º C). High humidity will increase drying time.